top of page

CX vs. VX: Same Copper, Non-Hollow Point vs. Hollow Point

Writer: Velocitas Bullets
Velocitas Bullets
2 hours ago
4 min read

We make two kinds of rifle bullet, and the names are close enough that people mix them up. Both are solid copper, and both are machined and loaded here in Amarillo, Texas. The difference is at the front of the bullet: CX is a non-hollow point, and VX is a hollow point.

Cutaway drawing comparing the non-hollow point CX bullet to the VX bullet with a hollow point and three slits cut into the ogive radius
CX and VX in 6mm ARC, drawn from our shop drawings. Not to scale.

VX: a hollow point with slits in the ogive radius

VX is a hollow point with slits cut into the ogive radius, the curved section that runs from the tip back to the body of the bullet.

When it hits, the hollow point fills with fluid from the target, and that creates pressure pushing outward from inside the cavity. The slits let that pressure do its work: the petals between them are forced outward until they break off in the first inch or two. That's where the VX does most of its damage.

What's left on our rifle VX is a solid copper core, about 75% of the bullet's weight, and it keeps penetrating past the point where the petals broke off. It's built for hunting.

Our VX9 in 9mm has the same hollow point and slits, but it's designed so its petals open and stay attached. That story is in our post on why we cut slits in the VX9.

CX: a non-hollow point

CX is a non-hollow point. No hollow point, no slits. It's built to stay in one piece, for competition and for shooting through barriers.

In flight. Leaving out the hollow point and the slits is what makes the CX fly better. Every bullet has to push air out of the way, and two parts of the bullet's front end do most of that work: the meplat, the small flat face at the very tip, and the ogive radius, the curve that runs back from the meplat to the body. On the VX, the hollow point opens a cavity in the meplat, and the slits break up the surface of the ogive radius. Both disturb the air flowing over the bullet and add drag. The CX has neither. Its meplat is solid, and its ogive radius is one smooth, unbroken curve, so the air flows around it more cleanly.

Less drag is what a higher ballistic coefficient (BC) measures. A bullet with a higher BC holds its speed better on the way downrange, drops less, and drifts less in the wind. You can see it in our numbers below. The CX and VX in each cartridge weigh almost the same, so most of the gap in BC comes down to the shape of the meplat and ogive radius.

Through a barrier. The sharp ogive radius is also what makes the CX good through barriers. When it hits something hard, the sharp point bites in instead of glancing off, so it's much less likely to be deflected. It carries its momentum through the barrier and keeps going on the line it was fired on.

In the target. In our gel testing of the CX in 6.8x51, the bullet turned sideways right after impact instead of opening up. Its ogive radius is sharp enough that when it hits, the tip begins to peel back and curl over on itself, like a banana peel. That pushes the tip off center and puts the bullet into yaw or pitch, turning it away from its line of flight. Glass doesn't curl the tip that way. A pane is a single thin layer that shatters outward as the bullet hits, so the push on the tip is over almost at once. In gel, fluid presses on the tip from every direction the whole way through, and that steady pressure is what curls it.

The numbers, from our own range

We measure BC ourselves with an Oehler System 89 chronograph. It clocks each bullet 10 feet in front of the muzzle, then again at a fly-over target 507 yards downrange, and works out the BC from how much speed the bullet lost on the way. We enter the temperature, air pressure and humidity for every session, and the Oehler uses them to correct each shot to a standard atmosphere, so a hot day and a cool day can be compared fairly. The figures below average every shot that reached the target.

6mm ARC (14.5-inch gas gun)


CX 89 gr

VX 91 gr

G1 BC

.482

.335

Speed 10 ft from the muzzle

2,670 fps

2,672 fps

Speed at 507 yards

1,920 fps

1,640 fps

Time of flight to 507 yards

0.673 s

0.728 s

.308 Win (18-inch rifle)


CX 159 gr

VX 160 gr

G1 BC

.509

.379

Speed 10 ft from the muzzle

2,783 fps

2,789 fps

Speed at 507 yards

2,046 fps

1,832 fps

Time of flight to 507 yards

0.638 s

0.674 s

Conditions at our range in Amarillo, Texas


6mm ARC sessions

.308 Win sessions

Temperature

68 to 85 °F

76 to 78 °F

Station pressure

26.31 to 26.60 inHg

26.30 to 26.50 inHg

Humidity

48 to 88%

42 to 50%

Wind

3 to 7 mph

4 mph

In each cartridge, the CX and VX leave the barrel at almost exactly the same speed. By 507 yards, the 6mm ARC CX is about 280 fps faster than the VX and gets there about 0.055 seconds sooner. In .308 the CX is about 210 fps faster. That's the drag difference from the meplat and ogive radius, showing up on the chronograph.

A tray of 6mm ARC rounds with a VX and a CX cartridge lying on a clear ballistic gel block
6mm ARC VX and CX rounds on a gel block in our shop.

Which one should you buy?

If you hunt, buy the VX. For competition, long-range shooting, or getting through a barrier, buy the CX.

Both come in 6mm ARC and .308 Win. We also make a CX in 6.5 Creedmoor. There's no VX version in 6.5 yet; that one is still in testing.

Not sure which one fits what you're doing? Send us a message and we'll help you pick.


 
 
 

Comments


bottom of page